Table of Contents
Advertisement
SLIP CLUTCH ADJUSTMENT
The slip clutch is factory preset to the correct torque
for protecting implement and tractor, and should
seldom require adjusting. Should adjustment be
needed, first check to be sure all spring lengths are
within 1/16" (1.6 mm). If necessary loosen nuts on
any springs that are unequal. Adjust all eight spring
retaining nuts 2/3 of a
clutch slippage. If farther adjustment is necessary,
adjust in 1/3 turn increments or consult your HONDA
Compact Tractor Dealer. Adjust only to provide
sufficient torque to prevent slippage under normal
conditions. When rocks, roots, etc., are present,
occasional slippage is normal for drivetrain
protection.
SPECIFICATIONS
Approximate Working Width
Inside Housing Width
.................................................................................................................................................
Input RPM
Required P.T.O. HP Range
................................................................................................................................
Type Hitch
...........................................................................................................................
Rotor Shaft Speed
.....................................................................................................................
Gearbox rations
Deck Material
..................................................................................................................................
.......................................................................................................................................
Tilling Depth
..............................................................................................................................................
No. of Blades
.............................................................................................................................
Implement Weight
.................................................................................................................................
Shipping Weight
(4 flats on nut) and check
turn
..................................................................................................................
...............................................................................................................................
...................................................................................................................
52"
5 1"
'
540
11- 40
3-point Cat. I
220 RPM
-
Input
1.461: 1
1
Lateral
-
1.687
:
1/8" steel
0" - 5"
32
341 lbs.
390 lbs.
Advertisement
Table of Contents
