Table of Contents
Advertisement
TRANSPORTING and STORING
-
OPEN
+k
There is one very important thing to
remember when transporting
your
mower: when you open the pump
bypass valves to move the mower
without the running engine, you
disable all braking action. For this
reason:
l
Always close both pump bypass valves after moving the
mower by hand.
l
Always drive the mower under its own power on any
incline.
l
If you must move the mower on an incline without
running the engine, use a suitable device (winch, block &
tackle, come-along).
Remember that the mower weighs
over 272 kg (600 lb).
l
When moving the mower without running the engine, do
not move it at more than a walking speed or more than
91 meters (100 yd). Be sure the bypass valves are open
at least one turn but not more than two turns.
See page 28 for more information on operating the bypass
valves.
Transporting
your Mower
Use a loading ramp to get the mower on and off the vehicle.
Be sure both the ramps and vehicle are able to support the
weight of the mower and operator.
When the mower is in position, turn the fuel valve OFF to
prevent the possibility of fuel leaking.
Tie the mower down, front and rear, with ropes or straps.
You may use the front caster brackets and the rear cross
member to tie the mower down. Be careful not to damage
hoses or linkages when tightening the ropes or straps.
Remember that the engine and exhaust system become hot
during operation. Avoid touching them.
16
Advertisement
Chapters
Table of Contents
