Extron electronics MLS 100 A User Manual page 3

Quick Start Guide — MLS 100 Series
To install and set up the MLS 100 Series switchers, follow these steps
and see the appropriate section of this manual for details:
Step 1
Turn all of the equipment off and disconnect the power cords.
Step 2
Mount the switcher (if applicable) or affix the rubber feet to the
bottom of the switcher for tabletop use. See
Step 3
Attach the cables. See the instructions beginning on
Laptop
1 2
INPUTS OUTPUT
AUDIO INPUTS AUX/MIX PREAMP CONTROL/
1 2 3 4
L R L R MONO L R POWER
A B
MLS 102 VGA 12V .5A MAX
MLS 102 VGA
Unbalanced,
VCR
Stereo Input
A B C D E
IR
Display/Source Control
Wireless Balanced/Unbalanced,
Microphone's Mono Aux. Input
Receiver
Balanced/
Unbalanced
Output
Amplifier
For the Aux/Mix Mono audio input, connect a 3.5 mm,
3-pole captive screw connector to one end of an audio
cable as shown at right. This line level input can be
balanced or unbalanced. Wire the other end to one
tip-ring-sleeve connector.
The Aux/Mix level must be adjusted
(-43 dB to +24 dB) via the front
panel control. It cannot be adjusted
via software, RS-232, or an MLC.
™ ©
MediaLink VersaTools Switchers • Quick Start Guide
page 2-2.
page 2-5.
Projector
NOTE Ground all devices. If you use
cable that has a drain wire, tie the
drain wire to ground at both ends.
To connect a computer or control
system, see page 2-8.
External
Power Supply
A B C D E 1A 1B 2A 2B 3A 3B A B C D 1 2 3 4 5 6 A B
RS-232 Tally Out MLS/Power
Relays IR / RCM Extron Switcher Control
MLC 206
Bottom Panel
AUX/MIX
MONO
Tip (+)
Gnd (Sleeve, )
Ring (–)
Aux/Mix Input Wiring
(balanced/unbalanced, mono)
QS-1