Advertisement
CARE AND MAINTENANCE
fig. 6
fig. 5
CAUTION: Remove the unit from
3 Holding the carry handle, place
the charging stand before any
the dust cup inside a trash
servicing.
receptacle and press the lower
dust cup door release button.
EMPTYING THE DUST CUP
Gently tap the dust cup to
dislodge and release dust and
To maintain the best performance of
debris. (fig. 6)
your vacuum, empty the dust cup after
Important: If the Dust Cup Door
every use or as debris approaches the
does not swing open after press-
"MAX FILL" line. Never operate the
ing the release button, push the
vacuum without the dust cup and filter
door open using the bottom door
in place.
tabs.
1 Turn off the vacuum before
4 Snap the door back in place.
removing the dust cup.
2 Press down on the dust cup
release button (fig. 5) and pull out
the dust cup.
6
TOLL FREE: 1-800-798-7398
fig. 8
fig. 7
5 If you notice hair or other debris
wrapped around the metal screen
in the upper chamber of the
dust cup, press the upper dust
cup door release to open the
top of the dust cup. Lift out the
metal screen, clear any debris and
replace. Snap the door back into
place. (fig. 7)
6 Replace the dust cup by first
seating the lower part of the dust
cup, then pushing in the top part
until it clicks. (fig. 8)
fig. 10
fig. 9
CLEANING THE FILTER
•
DO NOT use a hair dryer or
other forced hot air to dry the
Your vacuum has a high efficiency
filter.
dust cup to maintain strong suction by
•
DO NOT operate the vacuum
preventing debris from collecting on
without the filter in place.
the filter. To maintain strong suction,
it is important to clean the foam filter
•
DO NOT operate the vacuum
every month, under normal use.
with a wet filter.
1
Turn off the vacuum and remove
NOTE: It is normal for your foam filter
the dust cup.
to discolor over time; it will not
affect the filter performance.
2 Remove the foam filter (fig. 9) and
rinse under water until the water
CLEANING THE MOTORIZED
runs clear. (fig. 10) Squeeze the
BRUSH AND CLEARING
excess water out of the filter and
BLOCKAGES
let it air dry for 24 hours before
replacing.
An accumulation of hair, string, and
other debris may sometimes become
lodged in the flexible air hose of the
fig. 11
fig. 12
motorized brush, in the air inlet of
the dustcup or wrapped around the
brush roll. These areas must be free
from debris for maximum cleaning
performance. To clear blockages and
clean the brush roll:
1 Ensure the vacuum is off.
2 Press the release button located
on the rear of the main body and
remove the motorized brush.
(fig. 11)
3 To clear the air hose, flip back
the connector to straighten the
air passage (fig. 12) and carefully
remove any debris lodged in the
air hose. DO NOT USE SCISSORS
OR OTHER SHARP OBJECTS AS
THESE MAY DAMAGE THE HOSE.
www.sharkclean.com
7
Advertisement
