Vii. Disassembly And Assembly - Pride Mobility VICTORY SERIES Owner's Manual

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
Frame Separation
1. Arrange the front wheel(s) in a straight for-
ward-facing position.
2. Lower the tiller and tighten the tiller adjust-
ment knob.
NOTE: The pivoting tiller is equipped with a
mechanism that will lock the front wheels in
place when the tiller is completely lowered and
secured.
3. Grasp and lift up on the frame release lever.
See figure 21.
4. Lift the front section up until the frame hooks
of the front section separate from the rear sec-
tion. See figure 22.
5. Slowly separate the two sections. See figure 22.
ASSEMBLY
1. Position the front and rear sections of your
scooter as shown in figure 22.
2. Use the frame release lever to lift the front
section as you align the frame hooks of the
front section with the lower frame tube of the
rear section. See figure 22.
3. Once the frame hooks are over the lower
frame tube, lower the front section com-
pletely. This will engage the frame lock.
4. Raise the tiller and fully tighten the tiller
adjustment knob.
5. Reinstall the batteries to the battery wells.
6. Connect both battery harnesses. See figure 20.
7. Secure the battery tie-down strap.
8. Reinstall the battery shroud.
9. Reinstall the seat and rotate it into place.
36
Figure 21. Frame Release Lever
LOWER FRAME TUBE
Figure 22. Frame Separation
www.pridemobility.com
FRAME
RELEASE
LEVER
FRAME HOOKS
Victory Series