Pride Mobility JAZZY 1143 Ultra Owner's Manual page 28

V . C O M F O R T
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 16.
2. Loosen the jam nut.
3. Turn the adjusting screw to raise or to lower the front
of the armrest.
4. Tighten the jam nut to lock the adjusting screw into place.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 17.
3. Slide the controller into or out of the armrest to the
desired position.
To change the controller position:
1. Turn off the power to the controller.
1. Turn the rear shroud fasteners one-quarter turn.
2. Remove the rear shroud.
3. Unplug the controller from the power base.
4. Cut the wire tie(s) that secure the controller cable to
the armrest and seat.
5. Flip up the armrest and loosen the setscrew. See
figure 17.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller cable along the seat frame and se-
cure with wire ties.
11. Plug the controller into the power base.
12. Reinstall the rear shroud and tighten the fasteners.
28
A D J U S T M E N T S
Figure 17. Underside of Armrest
www.pridemobility.com
CONTROLLER BRACKET
SETSCREW
Jazzy 1143 Ultra