Operating The Daily Start Timer; Remote Start Safety Features - Code Alarm CA 5053 Owner's Manual

To begin the 2 / 3 hour start up timer mode:
1. Turn the vehicle's ignition ON then OFF.
2. Press and hold the valet button.
3. Press the
4. Release the valet button.
To exit the 2 / 3 hour start up timer mode:
1. Turn the vehicle's Ignition ON.
OR
1. Activate the remote vehicle start feature using the remote
control.

Operating the Daily Start Timer

The system has the ability to start your vehicle based on a 24-hour countdown
timer. This feature requires a two-part activation sequence. From the remote,
pressing both the
timer (the vehicle will start 24 hours from this time). Next, When you are finished
operating the vehicle for the day, perform the following steps to complete the
process.
1. Turn the ignition ON/OFF (vehicle must be disarmed).
2. Within 10 seconds, while pressing the brake, press and release the
button twice.
3. The vehicle will emit 2 chirps and flash the parking lights 4 times.

Remote Start Safety Features

For safety and security reasons, the system will shutdown or prevent the remote
vehicle starter from activating if any of the following occur:
1. The vehicle hood is open.
2. The brake pedal is pressed prior to turning the ignition key to the ON
position.
3. The engine is over-revved (tach checking only).
4. Valet mode is active.
6
button 4 times, the system will;
a. When set for 3 Hour (default) - chirp 2 times and flash the
parking lights 4 times.
b. When set for 2 Hour - chirp 1 time and flash the parking
lights 2 times.
& buttons together will activate the 24 hour countdown
ca5053 rev A