Problem Solving; Spécifications Techniques - Euro-Pro Shark Professional UV210 Owner's Manual

FAMILIARISEZ-VOUS AVEC VOTRE ASPIRATEUR
VERTICAL
1. Sélecteur de mode silencieux/normal
2. Bouton d'alimentation On/Off
3. Dispositif de surveillance du filtre
Intelli-Sense
4. Compartiment de rangement
de l'électrobrosse
5. Bouton de relâche de la coupelle
6. Poignée de la coupelle à poussière
7. Coupelle à poussière
8. Plaque du filtre d'échappement
9. Phare
10. Sélecteur tapis-plancher
11. Témoins à DEL
12. Sélecteur de hauteur de tapis
Spécifications techniques
Tension : 120 V, 60 Hz
Intensité : 12 A
Avertissement : Les illustrations peuvent différer de l'appareil lui-même.
13. Tube télescopique
14. Poignée du boyau souple
15. Plumeau autonettoyant
16. Électrobrosse
17. Porte-tuyau
18. Boyau souple
19. Poignée de l'aspirateur
20. Porte-cordon à relâche rapide
21. Cordon d'alimentation
22. Relâche de la poignée
23. Brosse à épousseter
24. Brosse à meubles
25. Suceur plat
31

PROBLEM SOLVING

This appliance was inspected thoroughly and was in good operating condition when it
was shipped from the factory. If a minor problem occurs, it usually can be solved quite
easily when the cause is found. Therefore, this checklist is provided for your
convenience.
PROBLEM POSSIBLE CAUSE
1. Not properly plugged into
wall outlet.
Cleaner W on't
2. No electricity in wall outlet.
Run 3. On/Off switch not turned
on.
4. Motor thermostat tripped.
1. Full or clogged dust cup.
2. Wrong pile height setting.
3. Clogged nozzle or dust
inlet port.
4. Clogged hose.
Cleaner W on't
5. Broken belt(s).
Pick Up 6. Hose not inserted fully.
7. Dirty filters.
8. HEPA filter needs
cleaning or replacing.
9. Debris screen needs
cleaning.
Cleaner Picks
Up Moveable
Rugs Or
1. Wrong pile height setting.
Pushes Too
Hard
1. Broken belt(s).
Agitator Does
2. Belt(s) installed
Not Turn
incorrectly.
Air Driven
1. Rotating brush, turbine or
Turbo Brush
elbow obstructed.
Does Not
2. Belt broken.
Rotate Or 3. Hose obstructed.
4. HEPA filter or debris
Rotates
screen clogged.
Slowly
Air Flow
Restricted
1. Attachment use restricts
W ith
air flow.
Attachm ent 2. New carpet debris
clogging air path.
Use Sound
Changes
POSSIBLE SOLUTION
1. Plug in firmly.
2. Reset circuit breaker or replace
fuse.
3. Push on/off switch to on
4. Reset motor thermostat.
1. Clean dust cup.
2. Adjust setting.
3. Remove obstruction.
4. Remove obstruction.
5. Replace belt(s).
6. Push hose in securely.
7. Clean / change filters
8. Clean or replace HEPA Filter or
filter frame.
9. Clean debris screen.
1. Adjust setting.
1. Replace belt(s).
2. Check belt changing.
1. Clear obstructions.
2. Call 1-800-798-7398.
3. Clear obstruction.
4. Clean HEPA filter or debris screen.
1. Check attachment.
2. Remove obstruction.
12