Mesures De Précaution; Problem Solving - Euro-Pro Shark Infinity NV31 Owner's Manual

MESURES DE PRÉCAUTION
Important:
Si les conduits d'air dans l'unité, le tuyau ou le tube d'extension bloquent,
éteignez l'aspirateur et enlevez la substance qui bloque avant de
remettre en marche l'unité .
1. N'utilisez pas l'aspirateur trop près
des chaufferettes ou des
radiateurs.
2. Avant d'insérer la fiche électrique
dans la prise murale, assurez-vous
d'avoir les mains sèches.
3. Ne nettoyez rien de liquide avec
l'aspirateur.
4. Éloignez les cheveux, les
vêtements amples, les doigts, les
pieds et toute partie du corps des
ouvertures, du rouleau des
brosses rotatives et de toutes
autres pièces mobiles.
5. Lorsque vous tirez la fiche
électrique de la prise murale, tirez
la fiche et non le cordon
d'alimentation.
6. Ne pas se servir de l'appareil pour
ramasser quelque chose qui brûle
ou qui fume comme des cigarettes,
des allumettes ou de la cendre
encore chaude.
7. Ne PAS passer l'aspirateur sur le
cordon d'alimentation.
8. Ne pas utiliser sans le bac à
poussière, le collecteur cyclone ou
TOUS les filtres en place.
9. Avant de commencer à passer
l'aspirateur, assurez-vous d'enlever
les gros objets ou les objets pointus
qui pourraient endommager
l'aspirateur.
34
TROUBLESHOOTING
Changing the Headlight
WARNING:
To reduce the risk of electric
shock, the power cord must be
disconnected before performing
maintenance/trouble shooting checks.
Occasionally the headlight will require
changing.
1. Turn the vacuum off and unplug from
the electrical outlet.
2. With a flathead screw driver, insert the
end of the screwdriver into the two
slots on top of the headlight lens and
gently pull down. (Fig. 60)

PROBLEM SOLVING

This appliance was inspected thoroughly and was in good operating condition when it
was shipped from the factory. If a minor problem occurs, it usually can be solved quite
easily when the cause is found. Therefore, this checklist is provided for your
convenience.
PROBLEM POSSIBLE CAUSE
1. Not properly plugged into wall
outlet.
Cleaner W on't
2. No electricity in wall outlet.
Run
3. On/Off switch not turned on.
4. Motor thermostat tripped.
1. Full or clogged dust cup.
2. W rong carpet height setting.
3. Clogged air path.
4. Clogged hose.
Cleaner W on't
5. Broken belt(s).
Pick Up 6. Telescopic wand not inserted
fully.
7. Dirty filters.
8. Debris screen needs
cleaning.
Cleaner Picks
Up Moveable
1. W rong carpet height setting.
Rugs Or Pushes
Too Hard
Agitator Does
1. Broken belt(s).
Not Turn 2. Belt(s) installed incorrectly.
Air Flow
1. Attachment use restricts air
Restricted W ith
flow.
Attachm ent Use 2. New carpet debris clogging
air path.
Sound Changes
Lens Slots
Fig. 60
3. Lift out the headlight lens.
4. Remove the light bulb by pulling it out
carefully.
5. Replace the new bulb by pushing it in.
6. To replace the headlight lens, insert
the bottom tabs of the lens into the
holding slots and snap the top back
into place to secure.
POSSIBLE SOLUTION
1. Plug in firmly.
2. Reset circuit breaker or
replace fuse.
3. Push on/off switch to on
4. Reset motor thermostat.
1. Clean dust cup.
2. Adjust setting.
3. Remove obstruction.
4. Remove obstruction.
5. Replace belt(s).
6. Push telescopic wand in
securely.
7. Clean / change filters
8. Clean debris screen.
1. Adjust setting.
1. Replace belt(s).
2. Check belt changing.
1. Check attachment.
2. Remove obstruction.
15