Technical Data - Philips 107E61/00 Service Manual

1. General
1.1. Product description
This color monitor is specified as a display peripheral within an IBM
PS/2, VGA+ and advance VGA compatible system. The monitor
operates at horizontal line rates of 30
of 50 - 160 Hz, and can be connected to RGB analog
computers with above scanning frequencies.
1.2. Destination : See 9. Deviation table .
1.3. Basic data
1.3.1 Cathode ray tube
Dimensions
Pitch : 0.27
Deflection angle
Glass : dark
Light transmission : 52%(LG), 47%(HF), 46%(CPT), 53.5%(ORION),
Surface : IRIS(PHL)/AGARAS(CPT,LG,ORION)
Implosion protection : CRT is provided with P-mini-rim-band.
Black matrix : Yes
Phosphor : P22
EHT : 25 KV (Ib=0)
CRT source : LG, HF, CPT, ORION
1.3.2 Power supply
Main voltage : 90 - 264VAC, 47 - 63 Hz
Power consumption : 70 Watts normal, 75 Watts max.
Power cord length : 1.45 M
Power cord type : See 9. Deviation table
Power indicator : LED (green), non-protrude
: AUTO 30K 71 KHz
1.3.3 Horizontal scan
: 50 Hz - 160 Hz
1.3.4 Vertical scan
1.3.5 Input signals
1. Input signals : RGB analog
2. Signal input level
Video : 0 - 0.7 Vpp Linear / 75 ohms
Sync : Separate sync with TTL level
3. Impedance
Video : Terminated with 75 ohms
Sync : Terminated with 4K7 ohms pull down resistor
1.3.6 Input signals
Signals shall be applied to the display device through
a shielded cable 1.45 m long which is intended as a part of the
monitor (tolerance on cable length : +/- 50 mm).This cable shall
be a suitable type to comply with any specification item.
1.Pin assignment
VESA DDC2B DISPLAY :
15 pin D-shell male connector type AMP 211350-1 or equivalent,
with pin assignment as follows :
2.Signal cable
1.45M flying with 15 pin D shell socket (length tolerance : +/ - 50 mm)

Technical Data

71 KHz and refreshment rate
-
: 17 inch
: 90 degrees
-
Pin
Assignment
No.
1 Red video input
2 Green video input
3 Blue video input
Identical output - connected to pin
4
10
5 Ground
6 Red video ground
7 Green video ground
8 Blue video ground
107E6 CRT
3
Go to cover page
Pin
Assignment
No.
9 +5V DDC supply
10 Logic ground
Identical output - connected to pin
11
10
12 Serial data line (SDA)
13 H. Sync / H+V
14 V. Sync (VCLK for DDC)
15 Data clock line (SCL)