No Signal Input - Philips 107E61/00 Service Manual

12 107E6 CRT
Go to cover page
3) Press the button. The EXTRA CONTROLS window appears.
ADJUST MOIRE will be highlighted.
4) Press the button until DEGAUSS is highlighted.
5) To degauss your screen, press the
degaussed, then the MAIN CONTROLS will reappear. CLOSE MAIN
CONTROLS will be highlighted.
Smart Help After returning to MAIN CONTROLS...
...To exit completely, press the
CLOSE MAIN CONTROLS
OSD Adjustments (Continued)
button. Your screen will be
button.
Monitor specific troubleshooting
Self-test Feature Check(STFC)
Your monitor provides a self-test feature that allows you to check
whether your monitor is functioning properly. If your monitor and
computer are properly connected but the monitor screen remains
dark, run the monitor self-test by performing the following steps:
1. Turn off both your computer and the monitor.
2. Unplug the video cable from the back of the computer.
3. Turn on the monitor.
If the monitor is functioning properly, you will see a OSD message
as shown in the following illustration:
CHECK SIGNAL CABLE
This box also appears during normal system operation if the video
cable becomes disconnected or damaged. This box will remain on
for one minute, go off five seconds. Then on for one minute, and will
repeat cycle.
1. Turn off your monitor and reconnect the video cable:
then turn on both your computer and the monitor.
2. While in self-test mode, the LED remains green and the pattern
remains on and stationary.
If your monitor screen still remains dark after you use the previous
procedure, check your video controller and computer system; your
monitor is functioning properly.

NO SIGNAL INPUT

If there is something wrong with the input signal, a message appears
on the screen although the power indicator LED is still on. The
message may indicate that the monitor is NO SIGNAL INPUT or that
you need to check the signal cable.
NO SIGNAL INPUT