R E S E T T I N G T H E I C M T A P E F O R F U T U R E M E S S A G E; M O N I T O R I N G R O O M S O U N; C H A N G I N G T H E O U T G O I N G M E S S A G; S K I P P I N G T H E O G M F O R I C M R E C O R D I N - Panasonic Easa-Phone KX-T1451 Operating Instructions Manual

-'.ry---.
-
,J
,
- l r
How to Operate from a Remote Phone
\
recorded
After all the messages
have been played back.
after the
tr
CHANGING THE OUTGOING MESSAGE
You can re-record the Outgoing Message from a remote phone.
/
Catt your unit, and push the Code No. during the OGM.
Push "7" right after you hear the beep tones indicating the
number of recorded messages.
rShort beeps will be heard continuously until the OGM tape has
been reset, and then a long beep will be heard.
3
Speak clearly and loudly after you hear the long beep.
When recording is finished, push
"9".
oThe new Outgoing Message will be played back. So you can
check or amend it.
NOTE:
lf you pause for over 2 seconds while recording, you will hear a
series of warning tones (6 beeps). lf this happens, push
"7" within 10
seconds of hearing these beeps, and repeat from step 2 again.
SKIPPING THE OGM FOR ICM RECORDING
lf you or the caller does not want to hear the Outgoing Message, the unit can be
switched promptly to the Incoming Message mode.
1 Calt your unit.
2
Push " x " during the OGM
3
Speak clearly and loudly after you hear the long beep to record
your Incoming Message.
you have used Memory Playback
7 Push "3".
oThe unit will rewind the tape to the beginning of
newly-recorded messages and a beep will be
2 P u s h " 3 " a g a i n .
oA beeo tone will be heard and the
future messages will be recorded
from the beginning of the ICM tape.
IrbEFil
l t 3 i l |
l_:'J
arEEFr\ )
t_t4J
@
a _ \
I l x t l I
\-\Jl,
N
How to Operate from a Remote Phone
RESETTING THE ICM TAPE FOR FUTURE MESSAGES
To record new Incoming Messages from the beginning of the tape,
messages are played back or while they are being played;
/ P u s h " 3 " .
oThe unit will rewind the taoe to the
beginning and a beep tone will be
heard when the tape has been reset.
the
heard.
E
After you have used
the Memory Playback.
lf you have reset the tape by mistake
7 Push "2" atler the tape has been reset (one-beep), then hang up.
oThe unit will advance the taoe to the end of the recorded
messages.
MONITORING ROOM SOUND
You can screen any sound in the room where the unit is installed for 30 seconds.
/ Calt your unit and push the Code No. during the OGM.
Push "5" right after you hear the beep tones indicating the
number of the recorded messages.
oYou can listen for 30 seconds.
oTo listen further, push "5" again within 10 seconds of hearing
one Deep.
Memory
Playback
a--------.*-\\
IU]J
N
ar.-*l)
l_rg-J
fr
t
- 1 7 - - 1 8 -