Table of Contents
Advertisement
r
Other Features
ERASING THE RECORDED MESSAGES
After you have played back the recorded messages, you can erase them by simply
pushing the ICM ERASE button.
7 Push ICM ERASE until a beep is heard.
oThe unit will erase the recorded
messages while the tape is rewinding.
NOTE:
The taoe can be erased even if the
record-prevention (knock-out) tabs have been
removed.
MONITORING THE INCOMING CALLS
While an Incoming Message is being recorded, you can hear it, then you may
choose to pick up the telephone handset and speak to the caller before your caller
finishes leaving a message.
7 Adjust the volume control.
lf you want to talk to the caller during
recording of the lCM, litt the telephone
handset and talk.
The unit will automatically stop recording and
be ready to answer the next phone call.
- 1 3 -
How to Operate from a Remote Phone
On the following pages, we explain how to:
I
SETTING THE REMOTE CODE
I
PLAYING BACK MESSAGES
T PLAYING BACK NEWLY-RECORDED MESSAGES (MEMORY PLAYBACK)
T R E W I N D I N G / F A S T
F O R W A R D I N G T A P E W H I L E H E A R I N G T H E M E S S A G E S
T R E C O R D I N G A M A R K E R M E S S A G E
I
RESETTING THE ICM TAPE FOR FUTURE MESSAGES
I
M O N I T O R I N G R O O M S O U N D
T C H A N G I N G T H E O U T G O I N G M E S S A G E
I
S K I P P I N G T H E O G M F O R I C M R E C O R D I N G
I
SETTING/CANCELLING
THE ANSWER MODE
SETTING THE REMOTE CODE
To get remote access, you musl set and remember your remote code number.
The REMOTE CODE number is made up of 2 digits, the first digit is lactory preset, and
the second digit is selectable. ("2" or
"8")
EXAMPLE: lf the factory preset number is
"4", then your code number may be either
"42" or "48", depending on the position of the selectable REMOTE code
switch.
REMOTE CODE
@
,J Lt
The factory preset number is shown on the label to
the left of the switch. This is the first digit of your
Remote Code number. The second digit is
selectable (2 or 8).
- 1 4 -
Advertisement
Table of Contents
