Calling Party Control (CPC) Setting
Set to "A". (no call waiting service line.)
lf you have call waiting service or
some Incoming Messages are
interrupted, set to "8".
Number ot Rings
o 2 . . . . . . . . . . . . . .
T h e u n i t w i l l a n s w e r a c a l l o n t h e
o 4 . . . . . . . . . . . . . .
T h e u n i t w i l l a n s w e r a c a l l o n
the fourth ring.
oAUTO...... See "TOLL SAVER" on this
Recording Time Selector
o V O X . . . . . . . . T h e u n i t w i l l r e c o r d f o r a s l o n g a s
the caller soeaks.
o 1 m i n u t e . . T h e u n i t w i l l r e c o r d u o t o 1 m i n u t e ,
( 1 M r N )
The remote code number is made uo of
2 d i g i t s .
The first digit is factory preset, and the
second digit is selectable. (2 or 8)
Also, refer to page 14 for your remote code
The TOLL SAVER feature lets you avoid a toll charge when you call your unit and no
messages have been recorded.
7 Set tfre number of rings to AUTO.
olf the unit does not pick up on the third ring, hang up immediately. This means that
you have no messages and you have saved a toll charge.
The unit picks up on the second ring:
It means that at least one message has been recorded.
After you have played back all the messages from a remote phone, the unit will pick
up the next call on the fourth ring. lf the unit picks up on the second ring, it means
that at least one new message has been recorded.
4 . . B
2 . . .
A U T O
- 5 -
- 6 -
CASSETTE TAPE INSTALLATION
7 Open the panel, and insert the Outgoing
Message (OGM) and Incoming Message
(lCM) tapes as shown.
.Two cassette tapes are included. Use
C15 for OGM and C60 for lCM.
oDo not use endless loop cassette tape.
2 Connect the AC adaptor to the AC outlet.
3 Set tfre POWER ON/OFF switch to ON.
oThe unit will start to reset the OGM tape.
13 minutes after connecting the AC adaptor,
the unit will be powered ON automatically
and reset the OGM taoe even when the
POWER ON/OFF switch is not set to ON.
oAfter you have changed the OGM tape:
Push OGM PLAY and REW simultaneously
to reset the OGM tape.