Download Print this page

Location Of The Controls, Preparation - Panasonic Easa-Phone KX-T1000 Operating Instructions Manual

Automatic telephone answering system

Advertisement

Location of the Controls
INITIAL SETI''VGS
Connect the AC adaptor
.The Call Counter will show
"-" and the Answer
indicator
will flash.
Qalling Party Control (CPC)
Set to "A". (no call waiting
service line.) lf you have c-all
waiting Service or Incoming
Messages are interrupted, sEt
to B.
Number of Rings
o 5 . . . . . . . . . . .
T h e u n i t w i l l
answer a call on
the fifth rino.
.AUTO ... See "TOLL'
SAVER" below on
this page.
eAfter installing the tape, be sure to push the REW button until a beep is heard
to reset the tape.
I lf the tape is not inserted before plugging the AC adaptor, push the POWER
switch to OFF to insert the tape, and then push the POWER switch to ON.
TOLL SAVER
OGM PLAY Button
VOLUME Control
ANSWER Indicator
RING Selector
Power Switch
Micro Cassette Tape
P|AYBACKPAUSE
Button
Microphone (MlC)
Call Counter (Calls)
MEMO Button
(REW) Button
Preparation
CASSETTE TAPE INSTALLATION
CONNECTION
.USE ONLY PANASONIC AC ADAPTOR KX.AI1.
.The unit must not be connected to a coin operated line. lf you are on a party
line, check with your local telephone company.
oWhile operating the unit, the case of the AC Adaptor and the unit may feel warm,
this is a normal condition
-
The TOLL SAVER feature lets you avoid a toll charge when you call your unit
and no meessages have been recorded.
1 Set the number of rings to AUTO.
'lf the unit does not pick up on the forth ring, hang up immediately. This
means that you have no messages and you have saved a toll charge.
r The unit picks up on the third ring:
It means that at least one messaqe has been recorded.
I After you have played back all the riessages from a remote phone, the unit
will pick up the next call on the fifth ring. lf the unit picks'up on the third
ring, it means that at least one new message has been recorded.
;
]
',|
Insert the cassette tape (MC-30).
Single-Line
Modular Jack (RJ1 lC)
To Power Outlet
( A C 1 2 0 V , 6 0 H z )
Cord Holder DC Jack
Do not connect the AC adaptor to
the AC outlet belorc Inserting the
tape.
I
- 2 -

Advertisement

loading