Table of Contents
Advertisement
accessing the Router, which depend on the station's MAC addresses.
•
MAC Address - The wireless station's MAC address that you want to access
control.
•
Description - A simple description of the wireless station.
•
Privilege - Allow means allowing the station to access the Router. Deny means
denying the station to access the Router. 64-bit, or 128-bit, or 152-bit means
assigning a unique WEP key to access the Router.
•
WEP Key - Specify a unique WEP key (in Hexadecimal format) to access the
Router.
•
Status - The status of this entry, either Enabled or Disabled.
To disable the Wireless MAC Address Filters feature, keep the default setting, Disable.
To set up an entry, click Enable, and follow these instructions:
First, you must decide that the unspecified wireless stations can or cannot access the
Router. If you desire that the unspecified wireless stations can access the Router, please
select the radio button Allow the stations not specified by any enabled entries in the
list to access, otherwise, select the radio button Deny the stations not specified by
any enabled entries in the list to access.
To Add a Wireless MAC Address filtering entry, clicking the Add New... button. The "
Add or Modify Wireless MAC Address Filtering entry" page will appear that shown in
figure 5-12:
Figure 5-12: Add or Modify Wireless MAC Address Filtering entry
To add or modify a MAC Address Filtering entry, follow these instructions:
1. Enter the appropriate MAC Address into the MAC Address field. The format of
MAC Address is XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). For
example: 00-0A-EB-B0-00-0B.
2. Enter a simple description of the wireless station in the Description field. For
example: Wireless station A.
3. Privilege - Selects the privileges for this entry, one of Allow / Deny / 64-bit /
128-bit / 152-bit.
4. WEP Key - If you select 64-bit, 128-bit or 152-bit in the Privilege field, enter
TL-WR542G
- 28 -
54M Wireless Router User Guide
Advertisement
Table of Contents
