TP-Link TL-WR542G User Manual page 16

In the page, you can configure the follow wireless parameter:
Wireless Radio - indicates whether the Access Point feature of the Router is
enabled or not. If disabled, the WLAN LED on the front panel will not be lit and
wireless stations will not be able to access the Router. If enabled, the WLAN
LED will be lit up and wireless stations will be able to access the Router.
SSID - Enter a value of up to 32 characters. The same SSID must be assigned
to all wireless devices in your network. The default SSID is TP-LINK. This
value is case-sensitive. For example, TP-LINK is NOT the same as TP-Link.
Channel - the current channel in use. This field determines which operating
frequency will be used.
Mode - Indicates the current mode (54Mbps (802.11g), 11Mbps (802.11b)). If
you select 54Mbps (802.11g), it is compatible with 11Mbps (802.11b).
These settings are only for basic wireless parameters, for advanced settings, please
refer to section 5.5: "Wireless."
Note: The change of wireless settings won't take effect until the Router reboots! You can
reboot it manually. If you need instructions on how to do this, please refer to
5.11.3: "rebooting the Router"
Click Next button, you will see the Finish page:
After finishing all configurations of basic network parameters, please click Finish button
to exit this Setup Wizard.
TL-WR542G
Figure 4-9: Setup Wizard - Wireless settings
Figure 4-10: Setup Wizard - Finish
- 15 -
54M Wireless Router User Guide
section