HP OmniBook 800CS/CT Service Manual page 55

Setting
Key Repeat
Rate
Keyboard
Numlock
External Devices...
VGA Display
device
Force
recognition of
external VGA
Enable External
FN Key
Ignore External
Pointing Device
Audio Port...
Basic Audio...
Disable internal
Beeper volume:
Audio volume
Advanced Audio...
Audio
IRQ
DMA
Channel
Address
Wave 2 Audio
IRQ
DMA
Video Stretched
Enabled IrDA IR
36
Parameters
2 cps; 6 cps; 10 cps; 15
cps; 20 cps; 30 cps
Selected, Not selected
External VGA if attached,
LCD off;
Both external VGA and
LCD
Selected; Not selected
Selected; Not selected
Selected; Not selected
Selected; not selected.
0-7
0-7
5, 7, 9, 10
0, 1, 3
220, 230, 240, 250
11
0, 5, 6
Selected; not selected
Selected; not selected
Default Comment
10 cps Select the rate at which
keys will be repeated when
they are held down longer
than the Key Delay period.
Not selected Start computer with NUM
LOCK enabled.
External When 'External VGA...' is
VGA if selected, if an external
attached, VGA monitor is detected, it
LCD off; will be enabled and the
LCD will be turned off.
When 'Both external
VGA...' is selected, both
are ALWAYS on.
Not selected Available only when Both
external VGA and LCD is
selected.
Selected When enabled, CTRL +
ALT on external keyboard
acts as FN key.
Not selected This will ignore any
external pointing device.
Not selected. Disabling internal sound
board removes any
possible conflict with a
sound board installed in
the dock.
4
4 Sets master volume, not
volume ceiling.
If Boot devices only is
selected in Boot Devices
5 menu, then the Advanced
1 Audio menu will be
220 disabled.
11 IRQ is fixed at 11
5
Not Selected Option available on F1360
only. Set video to
Stretched or Centered
mode (if hardware
capable).
Selected Allocate resources needed
to enable IrDA Infrared
Port.