Disassembly, Cleaning And Care - Omega VRT400 SERIES Instruction Manual

DISASSEMBLY, CLEANING AND CARE

FIGURE IN ORDER
Juice outlet
14
DISASSEMBLY, CLEANING AND CARE
1. Ensure the motor stops completely and unplug the power cord.
When unplugging the power cord, hold the head part of the power cord and unplug it.
Do not touch the power cord with wet hands.
2. Hold the juice outlet and the hopper with both hands and lift them up from the base.
3. Disassemble the parts as below:
1) Unlock the bowl twisting to counterclockwise.
2) Take the screw out.
3) Remove the strainer.
4) Take the spinning brush out and disassemble the silicone brush.
4. Rinse each parts with cleaning brush. Brush the inside and outside under running water.
Never use scouring pads, abrasive cleaning agent aggressive liquids or sharp cleaning tools.
Do not wash them in a dishwasher or a dish dryer.
5. Wipe the stain on the base with soft damp cloth or wrung towel and dry the base thoroughly.
Do not immerse the base unit in water or any other liquid nor rinse, it under tap.
6. After each cleaning ,allow parts to air-dry completely and store in a clean and safe place.
Always wash the bowl set immediately after each use. If you skip this step, pulp may dry up and stick to the bowl set.
making it difficult to disassemble or wash. It may also cause degradation in performance.
15