HP NX9010 Service Manual page 150

Call Center:
Symptom Suggestions
LAN/network
General problems. Check cables and
connections.
Try connecting notebook to
another network station (if
applicable). If green light
next to LAN port does not
light, LAN cable may not be
connected to network or
network may be down.
Use networking
troubleshooter in Windows
Help.
Check settings in Control
Panel.
Make sure LAN cable is
Category 3, 4, or 5 for
10Base-T operation, or
Category 5 for 100Base-TX
operation. Maximum cable
length is 100 meters (330
feet).
Test LAN with e-Diagtools
diagnostics.
Infrared
General problems. Infrared is disabled and no
drivers installed as shipped.
(Drivers are included.)
Make sure line between
infrared ports is not blocked,
ports face each other
squarely and are no more
than 1 meter apart. Sunlight,
heat from nearby equipment,
or other sources of infrared
radiation can cause
transmission errors.
Open Hardware Device
Manager. Try to enable the
infrared port.
Remove any PC cards from
notebook (possible IRQ
conflict).
For fast-IrDA, check for
DMA conflict with ECP
parallel port.
Service Manual
Repair Center: Repair Center:
Likely Causes Comments
Motherboard.
Motherboard.
Troubleshooting and Diagnostics 3-15