Pin Connector Wiring - Fortress Automotive Security FS-89 Installation Handbook

BLUE/ORANGE: (-) 500mA Starter 2 Output
Some vehicles require a 2
ORANGE: (-) 500mA Starter Kill / Anti-Grind Output
This wire should be connected to the Black wire of the pre-wired relay socket for the starter disable. Connect the
Red wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect
each half to the Yellow and Blue wires on the relay socket as shown. This output also turns on with remote start to
function as an "Anti Grind" wire to prevent the starter from grinding if you get in your car and turn the key too far
after it was remote started. See starter disable diagram on next page.
CONNECT TO
ORANGE WIRE
OF ALARM
PRE-WIRED
STARTER DISABLE
RELAY & SOCKET
START OUTPUT
FROM ALARM
6-PIN HARNESS
WIRING: 18-PIN Connector
nd
start wire for remote start.
BLUE/ORANGE
STARTER
IGN. SWITCHED
STARTER WIRE
BLACK
BROWN
85 86
30 87
CUT
RED
YELLOW
BLUE
STARTER DISABLE:
7
CONNECT TO IGN
-
+
BATTERY
IGNITION SWITCHED
"ON" & HOT THROUGH
CRANKING
STARTER
MAKE CERTAIN TO
CONNECT BROWN
WIRE TO STARTER
MOTOR SIDE!!!