Fortress Automotive Security FS-89 Installation Handbook page 32

26. TRANSMISSION TYPE: Requires Tach Wire connected and programmed
This option selects automatic or manual transmission mode
1. Automatic Transmission – Default.
2. Manual Shift Transmission - Requires Remote Start Button pressed with (-) Hand Brake Activated.
3. Manual Shift Transmission – Starts Exit procedure with (-) Hand Brake Set and engine running.
4. Manual Shift Transmission – System finishes exit procedure automatically. Remote Starter shuts down 2
seconds after closing last door. Not necessary to press remote to set up manual transmission.
27. REMOTE CARJACK:
This option is used to enable Carjack Protection. Carjack is enabled by the remote control or Valet button while the
ignition is on and the doors are closed. Remote Carjack starts a 30 second countdown to trigger alarm. The Valet
button enables Passive Carjack, the door must open and close to start 30 second countdown. The Default = ON.
28. ARM & DISARM thru OEM REMOTE:
This option allows the OEM factory remote to Arm, Disarm and Remote Start the system. This feature only works on
newer CANBUS vehicle using a Data Module that supports this feature. You can select Arm and Disarm only or
Arm, Disarm and Remote Start (requires pressing lock 3 times). Default = OFF.
29. UNLOCK BEFORE REMOTE START:
This option is used to disarm an OEM Alarm System before Remote Start. Default = OFF
30. FACTORY DEFAULT: OPTION RESET
This resets all options to Factory Default. Press button #1 on the remote control to restore all Factory Defaults.
This system option restores all options to FACTORY DEFAULT VALUES as listed in the "Button #1" column of the
programmable option chart on pages 24-25. This can be helpful if you have lost track of the option settings on your
system, or when you are moving the system from car to car and want a "clean slate".
PROGRAMMABLE OPTION Cont.
32