Pci/Plug And Play Setup Page - ECS Motherboard User Manual

Motherboard User's Guide
PCI / Plug and Play Setup Page
This page sets up some parameters for devices installed on the
PCI bus and those utilizing the system plug and play capability.
CMOS SETUP UTILITY – Copyright (C) 1985-2004, American Megatrends, Inc.
Plug & Play Aware O/S
Primary Graphics Adapter
Allocate IRQ to PCI VGA
PCI IDE BusMaster
: Move
F1: General Help
Plug & Play Aware O/S
This itme select which, the BIOS or the operating system, will
configure all the devices in the system. If set NO, the BIOS
configures the system; set YES, the operating system configure
Plug and Play devices.
Primary Graphics Adapter
This itme indicates if the primary graphics adapter uses the PCI-E
VGA, PCI VGA or AGPro.
Allocate IRQ to PCI VGA
If this item is enabled, an IRQ will be assigned to the PCI VGA
graphics system. You set this value to No to free up an IRQ.
PCI IDE BusMaster
This item enables or disabled the DMA under DOS mode. We
recommend you to leave this item at the default value.
PCI / Plug and Play Setup
Yes
PCI-E VGA
No: lets the BIOS
Yes
configure all the
Disabled
devices in the system.
YES: lets the
operating system
configure Plug and
Play (PnP) devices not
required for boot if
your system has a Plug
and Play operating
system.
Enter: Select +/-/: Value F10: Save Esc: Exit
F9: Optimized Defaults
38
Help Item