Dn9848 Set U P Options; General; Remote Comms Channel; Security Settings (Pages 2 And 3) - Klark Teknik DN9848 Operator's Manual

7. DN9848 S
ET

7.1. General

The DN9848 provides various set up options for adapting the operation of the unit to best suit your
operational requirements and preferences, as follows:
Comms channel setting for remote control
Security features
Display lighting
Unit and memory naming
Delay units of measurement
Power up settings
These options are programmed in the Set Up menu and are described below in menu order.
To access the Set Up menu pages
Press HOME (SET UP) to return to the Home page.
Press and hold the HOME (SET UP) button to open the menu.
Press the HOME (SET UP) button repeatedly to step through the pages in turn.
Note that this menu does not 'cycle'. On completing the set up, the menu returns to the Home page.
7.2. Remote Comms Channel (Page 1)
This page specifies the communications channel on which the unit will send and receive data to/from
a controlling PC. Channels 1 to 32 are available, enabling a
slave network of up to 32 DN9848 Equalisers to be
controlled from a PC using Stardraw or Smaart software.
DN9848 remote control set ups are covered in Section 9.

7.3. Security Settings (Pages 2 and 3)

7.3.1 Front Panel Lock (Page 2)
This option is used to set a password and lock out the all, or nearly all, of the front panel controls to
protect settings from tampering by unauthorised
personnel. Five levels of Panel Lock are possible:
Unlocked – All controls available.
Lock + Recall – This leaves the Recall
button active so that saved memories can be
still be recalled.
Lock + Recall + Mute - As above but also
leaves the Mute controls active.
Lock + Mutes – Leaves the Mute controls
only active.
Locked – Imposes a full lockout on the front
panel controls.
In all cases, limited Set Up menu options remain available, namely the Comms Channel, Panel Unlock
pages and Power Up pages.
Security and other Set Up Options
U O
P PTIONS
19