Rtc Battery - HP MINI 210 Maintenance And Service Manual

2. Remove the memory module (3) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the memory module.

RTC battery

Description
RTC battery
Before removing the real-time clock (RTC) battery, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
Remove the RTC battery:
1. Lift the edge (1) of the battery from the system board.
44 Chapter 4 Removal and replacement procedures
Memory modules are designed with a notch (4) to prevent incorrect insertion.
Battery on page 37).
Service access cover on page
Spare part number
599516-001
38).