Safety - Chicago Electric 95136 Owner's Manual & Safety Instructions

General Tool Safety Warnings (cont.)
12. Proper cylinder care. Secure cylinders to a
cart, wall, or post, to prevent them from falling.
All cylinders should be used and stored in an
upright position. Never drop or strike a cylinder.
Do not use cylinders that have been dented.
Cylinder caps should be used when moving or
storing cylinders. Empty cylinders should be kept
in specified areas and clearly marked "empty."
13. Never use oil or grease on any inlet connector,
outlet connector, or cylinder valves.
14. Use only supplied Torch on this Inverter
Air Plasma Cutter. Using components
from other systems may cause personal
injury and damage components within.
15. This product, when used for cutting and
similar applications, contains or produces
a chemical known to the State of California
to cause cancer and birth defects (or other
reproductive harm). (California Health
& Safety Code § 25249.5, et seq.)
16. People with pacemakers should consult
their physician(s) before using this product.
Electromagnetic fields in close proximity to
a heart pacemaker could cause interference
to, or failure of the pacemaker.
Symbology
Page 4
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
n 0 xxxx/min. No Load Revolutions per Minute (RPM)
For technical questions, please call 1-800-444-3353.
17. USE PROPER EXTENSION CORD. Make sure
your extension cord is in good condition. When
using an extension cord, be sure to use one heavy
enough to carry the current your product will draw.
An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
A 50 foot extension cord must be at least
12 gauge in diameter, and an 100 foot extension
cord must be at least 10 gauge in diameter.
If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
18. This product requires a 3-prong, 240 V~,
twist-lock plug (not included). This plug must
be installed by a qualified electrician.
19. KEEP CHILDREN AWAY. All visitors should
be kept safe distance from work area.
20. MAKE WORKSHOP KID PROOF with padlocks,
master switches, or by removing starter keys.
21. USE RIGHT TOOL. Don't force tool or attachment
to do a job for which it was not designed.
22. SECURE WORK. Use clamps or a vise to
hold work. It's safer than using your hand
and it frees both hands to operate tool.
23. MAINTAIN TOOLS WITH CARE.
Keep tools clean for best and safest performance.
Follow instructions for changing accessories.
24. Inspect before every use;
do not use if parts loose or damaged.
Amperes
SKU 95136