Chicago Electric 95136 Owner's Manual & Safety Instructions page 10

Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Controls and Indicators
2 POWER
ON
1
WORKING
7
CUTTER
OFF
240 VOLT INVERTER PLASMA CUTTER
with Digital Display
TORCH
Preparing Your Work Area
1. You must have a sturdy work table that is
open below the area you are cutting. Molten
slag will be blown through the work metal,
and must be able to fall away freely.
2. Your work table must allow the work metal to be firmly
clamped to prevent it accidentally falling or moving.
Page 10
4
OVER-
POWER HEAT 3
5
SET
MIN MAX
6
CURRENT
AIR
ITEM 95136
Torch
Connector
GROUND
Ground
Connector
For technical questions, please call 1-800-444-3353.
1. Power Switch.
Up is ON, down is OFF.
2. Digital Amp Meter.
Shows actual cutting current,
which will vary during operation.
3. Thermal Overload Indicator Lamp.
This light will come on, and the device will
shut down if the tool becomes overheated.
Stop trying to use the cutter while leaving the
power switch ON to allow the cooling fan to
operate, and the lamp will turn off automatically
when the machine cools down.
Pay attention to Duty Cycle discussed on page 6.
4. Power ON Light.
5. Power Supply Controller.
6. Mode Selector.
Turns the air supply ON prior to cutting.
7. Working Indicator Light.
Will be on during cutting operation.
3. The floor and surrounding area of your work site
must not be flammable. A clean cement floor is
recommended. The cutting process will eject
molten metal slag onto the floor, and it will scatter
for 8-10 feet or more in any direction. Have an
adequate fire extinguisher available if needed.
SKU 95136