Clearing Jams - Central Pneumatic 39092 Assembly And Operating Instructions Manual

Anytime any maintenance or repairs are done (including clearing jams), FIRST:
1. Disconnect the Nailer from the air hose.
2. Empty the Magazine (6465) completely.
3. Attempt to fire the Nailer into a piece of scrap wood to ensure that it is discon-
nected and is incapable of firing any Brads.
4. Always leave the Magazine (6465) open during maintenance. The Magazine is
spring loaded, and may cause parts or a Brad to fly out of the Nailer.
1. Occasionally a Brad may become jammed in the firing mechanism of the Nailer,
making the tool inoperable. To remove a jammed nail, disconnect the Nailer from
its compressed air supply. Empty the Magazine (6465) completely of nails. Al-
ways leave the Magazine (6465) open during maintenance. The Magazine is
spring loaded, and may cause parts or a Brad to fly out of the Nailer. Attempt to
fire the Nailer into a piece of scrap wood to ensure it is disconnected and is
incapable of firing any nails.
2. With the Front of the tool pointed away from you, open the Driver Guide
Cover (6444), and remove the Driver Guide (6445). Use a pair of needle nose
pliers (not included) to remove the jammed Brad (usually from the Driver Guide
area). Then, replace the Driver Guide and close the Driver Guide Cover.
3. Reload the Magazine (6465) with Brads. Then, reconnect the air supply hose to
the tool.
4. Press the Safety Frame (6459) against a scrap piece of wood, and test fire the
Nailer several times while checking for proper operation. If the Nailer is properly
firing, you may continue using the Nailer. If the tool fails to perform properly,
immediately discontinue use and have it repaired by a qualified service techni-
cian.
5. When finished working, disconnect the air supply. Remove the Brads. Then,
store the Nailer out of reach of children.
SKU 39092 For technical questions, please call 1-800-444-3353.

Clearing Jams

Page 9