Bluetooth Module - HP CQ60 Series Maintenance And Service Manual

Bluetooth module

Description
Bluetooth module
Bluetooth cable
Before removing the Bluetooth module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Optical drive (see
b. Hard drive (see
c. Keyboard (see
d. Keyboard cover (see
e. Power button board (see
f. Display assembly (see
Remove the Bluetooth module:
1. Disconnect the Bluetooth module cable 1 from the system board. The Bluetooth cable is available using spare
part number 496836-001.
2. Remove the two Phillips PM2.0×4.0 screws 2 that secure the Bluetooth module to the base enclosure.
3. Remove the Bluetooth module 3.
Reverse this procedure to install the Bluetooth module.
Removal and replacement procedures
"Battery" on page
"Optical drive" on page
"Hard drive" on page 4-10)
"Keyboard" on page 4-17)
"Keyboard cover" on page
"Power button board" on page
"Display assembly" on page
4-7).
4-8)
4-20)
4-22)
4-23)
Spare Part Number
483113-001
496836-001
4–35