What To Do If - IKEA VALFRI User Manual

ENGLISH
1
Open the door fully.
3
45°
Close the oven door
to the first open po-
sition (approx. 45°).
Then pull forward
and remove it from
its seat.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The oven does not heat up.
The oven does not heat up.
2
Lift and turn the lev-
ers on the two hing-
es.
4
Hold the door strip
on the upper side of
the oven door on
both sides and
press this inwards in
order to loosen the
seal. Then pull the
door strip upwards
and off.
Possible cause
The appliance is deactiva-
ted.
The clock is not set.
5
Hold the glass pan-
el on their upper
side and it up and
out of its retainer.
Clean the glass panel with water and soap.
Dry the glass panel carefully.
Installing the glass panel and the door
When the cleaning is completed, install the
glass panel and the oven door.
Inserting the panel and the door:
1. Slide the glass door panel into the re-
tainer from above at an angle and then
lower the panel.
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
2. Hold the door strip on both sides, align
it with the inner edge of the door and
press the door strip into the upper edge
of the door.
3. Open the door as far as it will go.
4. Fold the clamp levers on both door
hinges down into their original position.
5. Close the oven door.
Activate the appliance.
Set the clock.
16
Remedy