Snapper 5900935 Operator's Manual page 48

Troubleshooting, Adjustment & Repair
Fine Adjustment Procedure (52" Models Only)
1. Loosen the jam nut (A, Figure 50) and turn the fine
adjustment bolt (B) to adjust the deck height until
the back measurement equals 4" (10,2 cm).
• Turn the bolt CLOCKWISE to raise the deck.
• Turn the bolt COUNTER-CLOCKWISE to lower
the deck.
2. Position the outside mower blades so that they
face front-to-back.
3. Re-measure from the front tip of the blade from
the cutting edge to the ground. Measure from the
rear tip of the blade from the cutting edge to the
ground. Repeat the process for the other side of
the machine.
4. Once the back measurement equals 4" (10,2 cm),
re-tighten the jam nut.
46
Figure 50. Fine Adjustment of the Deck Cutting
Height
A. Jam Nut
B. Fine Adjustment Bolt
B
A
www.SnapperPro.com