Cleaning And Caring For Your Oven - Simpson 904 Instruction Manual

3
C L E A N I N G A N D C A R I N G F O R Y O U R O V E N
IMPORTANT: Always make sure that your oven is turned off before you clean it.
Do not use steam cleaners.
Enamel
• Rub persistent stains vigorously with a nylon scourer or creamed powder cleansers. Note: You can also use
household oven enamel cleaners - follow the manufacturer's instructions carefully.
• Do not use harsh abrasive cleaners, powder cleaners, steel wool or wax polishes.
Stainless Steel
All grades of stainless steel can stain, discolour or become greasy. You must clean these areas regularly by
following the procedures below if you want your oven to look its best, perform well and have a long life.
Care must be taken when wiping exposed stainless steel edges...they can be sharp!
• Wash with warm soapy water and rinse with clean water.
• If you want a better look, clean your appliance with a suitable stainless steel cleaner then wipe with a soft
lint free cloth.
A suitable cleaner can be purchased from Electrolux Service or Spares.
Note: Make sure you follow the polish or brushing lines in the steel.
Grill
Always keep the grill dish clean as any fat left in it may catch fire.
Cleaning The Oven
Stirrup
Removing the Oven and Grill Door
Follow these steps to better access the oven for cleaning:
• Open door fully.
• Rotate the two stirrups forwards so that they are engaged onto the
hooks on the hinge arms.
• Hold the stirrups in place and slightly close the door. The stirrups will
now remain engaged.
• Close the door half way and lift it away from the oven.
• Do not lift the door by the handle, use one hand either side of
the door, keeping fingers clear of the hinge arms.
Location Notch
To Replace the Door
• Relocate both hinge arms at the same time into the front housing.
• Ensure that the location notches on the bottom of the hinge arms are positioned onto the lower cutout lip.
• Close the door partially to ensure that the location notch drops into place.
• When the hinges are located, open the door fully and ensure the stirrups are disengaged.
Note: Never use force and always ensure that the location notch is correctly engaged before you operate the
door.
IMPORTANT: Never lift or carry the door by the handle. Do not immerse the door in water.
22