Cleaning And Maintenance - Zanussi ZDC 47203W User Manual

Indicator lights
These lights indicate the following functions:
• Drying light: This light indicates that the ap-
pliance is in the drying phase.
• End/Anti-crease light: This light is on at the
end of the cooling phase, during the anti-
creasing phase and at the end of the pro-
gramme.
• Tank light: This light indicates that the appli-
ance is in the drying phase. This light comes
on at the end of the programme to remind
you that the water reservoir must be emptied
out. If this light illuminates during a pro-
gramme this means that the water reservoir
is full. The buzzer sounds, the programme
stops, the light of the Start/Pause button
flashes. This light comes on also when the
water reservoir is not inserted correctly.
• Filter light: This light illuminates at the end
of the programme to remind you that the fil-
ters must be cleaned.
• Condenser light: It comes on every 80 cy-
cles to remind you that the condenser must
be cleaned.
Changing programme
To change a programme which has been selec-
ted by mistake once the programme has star-
ted, first turn the programme selector to
OFF position. The programme is cancelled.
The programme can no longer be changed
directly once the programme has started. If

Cleaning and maintenance

Cleaning fluff filters
The filters collect all the fluff which accumulates
during drying. To ensure that the dryer works
perfectly, the fluff filters (fine filters and fluff fil-
ters) must be cleaned after each drying cycle.
Caution! Never operate the dryer without
fluff filters or with damaged or blocked fluff
filters.
1) Only dryers with buzzer button
www.zanussi.com
nevertheless there is an attempt to change the
programme on the programme knob or if an
function button (excluding the BUZZER but-
1)
ton ) is pressed, led on the START/PAUSE
button starts flashing temporarily in red. The
drying programme is not however affected by
this (laundry protection).
At the end of the programme
If the laundry is not removed at the end of the
cycle, the dryer performs an anticreasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anticreas-
ing phase. Lights End/Anti-crease , and
Tank remain lit and the buzzer sounds for 2 mi-
nutes.
Turn the programme selector dial to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant
smells.
If you open and then close the door before
turning the selector dial to
corresponding to the phases making up the
performed programme come on.
After each use
• Clean the filters.
• Empty the water reservoir.
to
all the lights
11