Clock Setting; Timer Setting; Sleep Timer Setting - TDK NX-7CD Instruction Manual

CLOCK/TIMER

Clock setting

1. In standby mode, press and hold MEM/
CLK SET, "12HOUR" or "24HOUR" is
displayed and flashing. Press
to change the hour mode.
2. Press MEM/CLK SET, the clock digits
for the hours flash. Press
to set the hours.
3. Press MEM/CLK SET, the clock digits
for the minutes flash. Press
to set the minutes.
4. PressMEM/CLK SET to confirm the
time.

Timer setting

The timer enables the system to switch on
and off in CD or Tuner mode at the specified
time as an alarm clock. The clock time
needs to be set first before the timer can
beused.
1. Press and hold TIMER on remote
control until "TIMER" and "ON" are
displayed. The clock digits for the hours
flash. Press
hours of ON time
2. Press TIMER on remote control. The
clock digits for the minutes flash. Press
or to set the minutes of ON
time.
3. Press TIMER on remote control.
"TIMER" and "OFF" are displayed and
the clock digits for the hours flash. Press
or to set the hours of OFF
time.
4. Press TIMER on remote control. The
clock digits for the minutes flash. Press
or to set the minutes of OFF
time.
5. Press TIMER on remote control.
"TUNER" or "CD" is displayed. Press
or to select your desired
source which will be started at the set
time.
or
or
or to set the
6. Press TIMER on remote control, "VOL
XX" is displayed. Press
adjust the volume level.
7. Press TIMER on remote control to
confirm the timer.
Press TIMER once on remote control.
Display shows "TIMER" if activated and
disappears if deactivated.
Note:
• When the OFF time is same as the ON
time, display shows "ERROR"and then
returns to timer setting for revising the OFF
time. In this case do not press the timer
button for several seconds to let the timer
setting mode return to normal. Then, you
can re-enter new timer start from step 1.
• If you selected CD mode for the source
of timer ON, a CD/MP3-CD disc must be
loaded into the system. In case you forget
to load a CD/MP3-CD disc into the CD
compartment. The system will also turn
on at the specified time but will change
to Tuner mode automatically.

Sleep timer setting

The sleep timer enables the system to
switch off by itself after a set period of time.
1. Press SLEEP o n re m o t e c o n t ro l
repeatedly to select a preset time. The
selections from 90 to 10 minutes,
decreasing in 10 minute increments.
2. Once the sleep time is selected,
"SLEEP" and the selected time appear
constant on the display.
3. To deactivate the sleep timer, press
SLEEP repeatedly on remote control
until "SLEEP" and timer goes off.
7
or to