Chapter 2: Installation; Autoview 3050/3100/3200 Switch Connectivity; Installation Overview - Avocent AutoView 3200 Installer/User Manual
Hide thumbs
Also See for AutoView 3200:
- Installer/user manual (185 pages) ,
- Specification sheet (2 pages) ,
- Quick installation manual (2 pages)
Table of Contents
Advertisement
CHA PTER
2
AutoView 3050/3100/3200 Switch Connectivity
The AutoView 3050/3100/3200 switching system transmits keyboard, video and mouse (KVM)
information between operators and target devices attached to the switch over a network using either
an Ethernet or modem connection.
The AutoView 3050/3100/3200 switch uses TCP/IP for communication over Ethernet. Although
10BaseT Ethernet may be used, Avocent recommends a dedicated, switched 100BaseT or
1000BaseT network for switches that support it.
Installation Overview
The general procedure for setting up and installing an AutoView 3050/3100/3200 switch is as
follows:
•
Unpack the switch and verify that all components are present and in good condition.
•
Make all hardware connections between the power source, switch, target devices, the Ethernet
and the optional modem connection.
•
Turn on the power and verify that all connections are working.
•
Configure the AutoView 3050/3100/3200 switch's IP address using the OSCAR graphical user
interface.
•
Use the On-board Web Interface (OBWI) to configure the AutoView 3050/3100/3200 switch.
•
Make the appropriate mouse setting adjustments.
Installation
3
Hide quick links:
Advertisement
Table of Contents
