Water Tank (For Products Equipped With A Condenser And A Heat Pump) - Blomberg TKF 7449 User Manual

To clean the sensors and drum fin;
1 Open the cover of your machine.
2 Allow the machine to cool off if drying has
been carried out.
3 Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning agents or
substances alike when cleaning as these
might cause fire and explosion!
Water tank (for products equipped
with a Condenser and a Heat pump)
The moisture in the damp laundry is taken from
the laundry and condensed. Drain the water
tank after each drying cycle or during drying
when "tank full" warning light comes on.
C
You can use the water in the water tank in
your steam irons or air humidifiers.
A
Never take out the water tank when the
program is running!
A
Condensed water is not drinkable!
If you forget to drain the water tank, your
machine will stop during the following drying
cycles when the water tank is full and the "Tank
Full" warning light will light on. If this is the
case, press the "Start/Pause/Cancel" button to
resume the drying cycle after draining the water
tank.
In order to drain the water tank;
1 Carefully pull the water tank to take it out.
2 Drain the water.
3 If there is lint accumulation in the cover,
clean it and press to close.
4 Slide in the water tank until it stops.
20 - EN