Installing A Second Tape Drive Or Replacing A Tape Drive; Preinstallation Requirements - Quantum 3U Quick Start Manual

Figure 3 Power Button

Installing a Second Tape Drive or Replacing a Tape Drive

Preinstallation
Requirements
Installing a Second Tape Drive or Replacing a Tape Drive
5 Connect the other end of the AC power cable to the rack/facility AC power
receptacle.
6 Press the master AC power switch on the front of the 3U Rackmount enclosure to
apply power to the enclosure and illuminate the power LED (see
7 Turn on all attached accessory devices, such as printers and other SCSI devices that
you turned off at step 2 of this procedure.
8 Turn on and restart the host server.
Follow these instructions to install a second tape drive or to replace a tape drive after it
has been removed.
Caution: Before installing a second tape drive, you must turn off the 3U Rackmount
enclosure and disconnect it from its AC power source.
Before installing a second tape drive in the 3U Rackmount enclosure, make sure you
have the following required tools and parts:
#2 Phillips screw driver
Tools
• A supported model tape drive
Parts
• SAS cable depending on the tape drive type
LTO-5 Full-Height Tape Drive
Figure 3).
Power LED
Power switch
3