Message Display - Panasonic lumix DMC-SZ8 Owner's Manual

Message Display

Confirmation messages or error messages will be displayed on the screen in some cases.
The major messages are described below as examples.
[This picture is protected]
•
Delete the picture after canceling the protect setting.
[Some pictures cannot be deleted]/[This picture cannot be deleted]
•
Pictures not based on the DCF standard cannot be deleted.
Perform formatting
[Built-in memory full. Please insert memory card.]/[Memory card full]/[Not enough
space on built-in memory]/
[Not enough memory on the card]
•
There is no space left on the built-in memory or the card.
•
When you copy pictures from the built-in memory to the card (batch copy), the pictures are copied
until the capacity of the card becomes full.
[Some pictures cannot be copied]/[Copy could not be completed]
•
The following pictures cannot be copied.
–
When a picture with the same name as the picture to be copied exists in the copy destination.
(Only when copying from a card to the built-in memory.)
–
Pictures not based on the DCF standard.
[Built-In Memory Error]/[Format built-in memory?]
•
This message will be displayed when you format the built-in memory on a PC.
Format the built-in memory on the camera again.
The data on the built-in memory will be deleted.
[Memory card error.
This card cannot be used in this camera.
Format this card?]
•
It is a format that cannot be used with this unit.
–
Insert a different card and try again.
–
Reformat on this unit
Data will be deleted.
[Please turn camera off and then on again]/[System Error]
•
This is displayed when the lens has stopped operating normally due to being pressed on by a hand
etc.
Turn the camera off and on. If the message persists, contact the dealer or Panasonic.
(P45) on this unit after saving necessary data on a PC, etc.
(P45) after saving necessary data using a PC, etc.
Others
(P91)
(P45)
- 137 -