Disconnect Stock Brake Line - StopTech ST-40 Caliper Installation Instructions Manual

Step 2 Step 2
Step 2 Step 2 Step 2

Disconnect Stock Brake Line

Disconnect Stock Brake Line
Disconnect Stock Brake Line Disconnect Stock Brake Line Disconnect Stock Brake Line
W W W W W ar ar ar ar arning: B ning: B ning: B ning: B ning: Br r r r r ake fluid will damage most painted sur ake fluid will damage most painted sur ake fluid will damage most painted sur ake fluid will damage most painted surfaces. I ake fluid will damage most painted sur
fluid from any painted surface. Also be sure that the cap is securely installed on the master fluid from any painted surface. Also be sure that the cap is securely installed on the master fluid from any painted surface. Also be sure that the cap is securely installed on the master
fluid from any painted surface. Also be sure that the cap is securely installed on the master fluid from any painted surface. Also be sure that the cap is securely installed on the master
cylinder cylinder . If the cap is loose or r . If the cap is loose or r
cylinder cylinder. If the cap is loose or r cylinder . If the cap is loose or r . If the cap is loose or remo
installation. installation. installation. installation. installation.
Place a drip tray or several rags directly below
the inboard brake line connection. If the area
around the brake line connection to the chassis
is dirty, clean it using brake cleaner or an ap-
propriate cleaning agent.
Use a 13mm flare wrench to slightly loosen the
hard line fitting.
Remove the hard line fitting, and quickly place
one of the rubber caps over the end of the hard
line, to control fluid loss during the installation.
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
faces. I faces. I faces. I faces. Immediately clean spilled br
emo emov v v v v ed, it is likely that mor emo ed, it is likely that mor ed, it is likely that mor
emo ed, it is likely that mor ed, it is likely that more fluid will drip during br
Use needle-nose or small standard pliers to re-
move the bracket holding the inboard end of
the stock brake line to the chassis bracket. Take
care to retain the clip for later use.
www.stoptech.com
mmediately clean spilled brake mmediately clean spilled br mmediately clean spilled br mmediately clean spilled br
e fluid will drip during br e fluid will drip during br
e fluid will drip during br e fluid will drip during brake
ake ake ake ake
ake ake
ake ake
8