Setup; Ac Power; Ac Plug; Fuse Replacement - Chauvet Rogue R2 Spot User Manual

Setup

3. S
ETUP

AC Power

AC Plug

Fuse
Replacement

Power Linking

DMX Linking

DMX
Personalities
-6-
Each Rogue™ R2 Spot has an auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each Rogue™ R2
Spot, refer to the label affixed to the product. You can also refer to the
chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the CHAUVET® website:
www.chauvetlighting.com/download/pro.
Always connect this product to a protected circuit with an appropriate electrical ground
to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
The Rogue™ R2 Spot comes with a power input cord terminated with a Neutrik® powerCON®
A connector on one end and an Edison plug on the other end (U.S. market). If the power input
cord that came with your product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from the power outlet.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a another fuse of the same type and rating
(F 7 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product's power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
The Rogue™ R2 Spot supports power linking. You can power link up to 5 products at 120 V; up
to 8 at 208 V; or up to 9 at 230 V.
This product comes with a power input cord. Power linking cables are available from
CHAUVET® for purchase.
You can link the Rogue™ R2 Spot to a DMX controller using a 3- or 5-pin DMX connection. If
using other DMX-compatible products with the Rogue™ R2 Spot, you can control each
individually with a single DMX controller.
The Rogue™ R2 Spot uses a 3- or 5-pin DMX data connection for the 18- and 21-channel DMX
personalities.
·
Refer to the Introduction
·
Refer to the Operation
these personalities.
·
The DMX Values section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller,
download the
www.chauvetlighting.com/download/pro.
Wire (U.S.)
Black
White
Green/Yellow
chapter for a brief description of each DMX personality.
chapter to learn how to configure the Rogue™ R2 Spot to work in
DMX Primer
Technical Specifications
Wire (Europe)
Brown
Blue
Green/Yellow
from the CHAUVET®
Rogue™ R2 Spot User Manual Rev. 2
Screw Color
Yellow or Brass
Silver
Green
website: