Table of Contents
Advertisement
DISCRIMINATION SYSTEM
Target Detection
Sweep the detector back-and-forth
over the ground.
Keep the searchcoil parallel to the
ground as you sweep; do not lift the
searchcoil at the ends of your
sweeps.
Searchcoil motion is required for
target detection (except in Pinpoint
Mode).
Target-ID
When objects are detected, the detector will emit a sound and a 2-digit Target-
ID will appear on the screen. Possible Target-IDs range from 1 to 99. This
number represents the electrical conductivity of the target detected; higher
numbers indicate more highly conductive targets.
The 2-digit number indicates the Target-ID of the last object detected. The
Eurotek Pro has a very fast target response and is able to detect different
objects in very close proximity. Therefore, the Target-ID displayed may change
rapidly as you sweep the searchcoil.
Three seconds after the last Target-ID is displayed, the Target-ID will time-out
and the number will disappear.
Bulgarian 10
Bulgarian 50
stotinkas, 1999
stotinkas,
1999 - 2007
50 kopeek
Nikolay II,1896,
5 kopeek,
Silver
Ekaterina II, 1781
14
CORRECT
WRONG
Peter I, 1705,
Mikhail
Fedorovich,
Silver, 0.25 gr.
1613-1645
2 kopeek,
10 ct Napoleon III
(bronze, France)
Alexander I, 1816
MENU SELECTIONS
Operational Overview
Press
to activate the menu system: SENS, DISC or VOL.
At first activation of the menu system, the SENS menu selection appears.
Successive presses of
will toggle through the menu selections.
With a menu selection visible, press
menu selection.
When you reach the desired setting, as indicated by the 2-digit value on the
display, no further action is necessary.
• 4 seconds after the last
out and the last displayed setting will be programmed in.
• Or press
again before the display times out, and advance to the next
menu selection; the last displayed setting will be programmed in.
During operation, recall the last menu selection by pressing MENU at any
time; the last menu selection adjusted will again be displayed.
While the MENU display is active, the LCD display will not respond to targets, but
the audio target system will continue to respond to any target or overload signal.
1. SENS (Sensitivity)
Press
to illuminate the SENS menu icon.
Use
and
to increase or decrease sensitivity while SENS is
highlighted.
Maximum sensitivity setting is 10.
Minimum sensitivity setting is 1.
If the detector beeps erratically or beeps when there are no metal objects
being detected, reduce the sensitivity.
The searchcoil produces a magnetic field and then detects changes in that
magnetic field caused by the presence of metal objects. This magnetic field
that the detector creates is also susceptible to the electromagnetic energy
produced by other electronic devices. Cell phones, cell phone towers, power
lines, microwave ovens, lighting fixtures, TVs, computers, motors, etc.... all
produce EMI which can interfere with the detector and cause it to beep when
no metal is present, and sometimes to beep erratically.
or
to change settings for that
or
key-press, the menu icon will time-
11
Hide quick links:
Advertisement
Table of Contents
