Removing / Replacing Drain Handle; Removing / Replacing Impeller - European Touch FORTE’ Owner's Manual

Tools required:
Phillips head screw driver
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
"Crystal Clean™ Pipe-Free
Whirlpool
(With Jets)
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: To remove the chrome handle pull it
forward. If difficult to remove, gently pry it off
with the screwdriver.
Step 2: To remove the handle adapter, place
Phillips head screwdriver into upper slot to reach
screw, as show n in picture above. Unscrew and
then pull adapter forw ard.
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com. Refer to the cleaning procedure page headed
"Crystal Clean™ Pipe-Free
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: Remove the Tee Knobs
by turning counter clockw ise.
Step 2: Lift the footplate to
remove.
Document ID:06080001

Removing / Replacing Drain Handle

®
Spa - Cleaning and Disinfecting Procedures," page 17, and "Traditional
- Spa Cleaning and Disinfecting Procedures," page 19, for cleaning

Removing / Replacing Impeller

®
Spa - Cleaning and Disinfecting Procedures," page 17, for cleaning
Step 3: Unscrew to remove the
impeller knob.
Step 4: Lift the impeller.
Rev: E
Step 3: Picture, w ith the adapter removed,
show n for cleaning reference.
Step 4: Picture, w ith Drain Plunger removed,
show n for cleaning reference.
Step
through 4 in reverse to replace
the parts.
Step 6: Press firmly dow n on
footplate to help
tightening Tee Knobs.
Technical Support: 800-626-6912
5: Complete steps
seal w hile
Page 22 of 24
1