AEG HK683320FG User Manual page 14

14 www.aeg.com
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The residual heat indica-
tor does not change col-
ours.
The Automatic Heat Up
function does not oper-
ate.
The heat setting changes
between two levels.
The sensor fields be-
come hot.
There is no signal when
you touch the panel sen-
sor fields.
The backlight is on, but
the contrast of the dis-
play is bad.
II and text come on.
comes on.
? comes on.
Problem Possible cause
The STOP+GO function
operates.
There is water or fat
stains on the control
panel.
You put something on
one or more sensor
fields.
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting
is set.
The Power management
is activated.
The cookware is too
large or you put it too
near to the controls.
The signals are deactiva-
ted.
The hot cookware is on
the display.
The Automatic Switch
Off operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
Remedy
Refer to the chapter
"Daily Use".
Clean the control panel.
Remove the object from
the sensor fields.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Refer to "Power man-
agement".
Put large cookware on
the rear cooking zones if
necessary.
Activate the signals (refer
to "Deactivation and ac-
tivation of the sounds").
Remove the object and
let the appliance be-
come sufficiently cool. If
the contrast is not clear,
speak to the service cen-
tre.
Deactivate the appliance
and activate it again.
Refer to the chapter
"Daily Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.