Installing The Modules - DFI G486VPB User Manual

Note:
If you are installing only one SIMM, you can install it in
any of the sockets. The bank you choose is considered to
be Bank 0/1.

Installing the Modules

An HSIM module simply snaps into a socket on the
system board. Pin 1 of the HSIM module must corre-
spond with Pin 1 of the socket.
1. Position the HSIM module above the socket with the
"notch" in the module aligned with the "key" on the
socket.
2. Seat the module at a 45
sure it is completely seated. Tilt the module upright
until it locks in place in the socket.
o
angle into the bank. Make
G486VPB
39