Table of Contents
Advertisement
Operational overview
Powering On and Off the HP TFT7210R
Press the Power On/Off button.
Accessing the OSD main menu
Press the Menu Select button on the front panel
1.
OSD Main menu appears and the default settings are shown when first accessing this menu.
Scroll down by pressing the Minus (-) button, or scroll up by pressing Plus (+) button.
2.
Press the Menu Select button to activate the highlighted menu item.
3.
If the Menu Select, Minus (-), or Plus (+) buttons remain untouched for the time duration that has been set
by the OSD Timeout (on page 18) function, any new settings that have not been saved will be discarded
and the previously saved settings are restored.
Exiting the OSD Main Menu
From the OSD Main menu, highlight Exit, and then press the Menu Select button to exit and close the OSD
Main menu.
Sleep Mode
After losing video signal, for supported video resolutions, a "Check Cable" message appears and is
stationary for two seconds. The display then goes blank, the monitor powers off, and the LED is amber.
For unsupported video modes that exceed 1280 X 1024 at 76 Hz, the display has a black background,
the LED is amber, and a "Selected resolution is not within recommended range of operation" message
appears for 20 seconds. After losing video signal, the message disappears.
Input signal out of range
An input signal that is outside the normal range of operation defined by the capabilities of the HP
TFT7210R, causes a "Selected resolution is not within recommended range of operation" message to
appear for 30 seconds.
("Front Panel LEDs and
Buttons" on page 5). The
Operational overview 11
Advertisement
Table of Contents
