Table of Contents
Advertisement
Manual
Bridge (WDS) Mode
Select "Setup Wizard" on the left menu and the working mode selection interface will appear as the picture
below.
Select Bridge (WDS) and then click "Next". You will enter the WDS setup page as the picture below.
Bridge (WDS) working mode includes: Point to Point Bridge (WDS P2P), Point to Multipoint Bridge (WDS P2MP),
Wireless Repeater (Repeater). Users can select the mode according to need. Please refer to Chapter 4.1.2 for
detailed introduction.
Click "Enable Scan". AP will scan the available wireless device nearby automatically and display them under the
9
www.kraun.it
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Wireless Access Point Ceiling 300Mbps and is the answer not in the manual?