Table of Contents
Advertisement
Chapter 2.
Product Installation
You are recommended to install the product after configuring the settings of KR.KZ according to the guide in
chapter 3. The following steps take AP mode for example.
1. Use the included power adapter to power on the AP. You can also use POE power supply or POE switch to
power on the AP.
2. Connect one end of the network cable to the LAN port of KR.KZ, and another end to your Ethernet broadband,
switch or PC.
3. Connect wireless adapter to KR.KZ.
Please refer to the topology below:
2.1 Default Settings
The default mode setting of this device is AP (Access Point):
Item
Common Default Settings
Username
Password
IP Address
Subnet Mask
Wireless
SSID
Wireless Security
Security Type
Criptazione (Encryption)
WPA KEY
DHCP Server
Default Value
admin
admin
192.168.0.254
255.255.255.0
KRAUN_the last 6 characters of MAC
address (example KRAUN_123456)
Enable
WPA-PSK/WPA2-PSK
TKIP+AES
KRAUN_KR.KZ
Disable
5
Manual
www.kraun.it
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Wireless Access Point Ceiling 300Mbps and is the answer not in the manual?