Cisco DPC2425 DOCSIS User Manual page 25

–
–
6 Locate the AC power adapter provided with your gateway. Insert the barrel
shaped DC power connector (attached by a thin pair of wires to the AC power
adapter) into the black POWER connector on the back of the residential gateway.
Then, plug the AC power cord into an AC outlet to power-up the gateway. The
residential gateway will perform an automatic search to locate and sign on to the
broadband data network. This process may take up 2-5 minutes. The modem will
be ready for use when the POWER, DS, US and ONLINE LEDs on the front panel
of the gateway stop blinking and remain ON continuously.
7 Plug in and power on your PC and other home network devices. The
ETHERNET LEDs on the gateway corresponding to the connected devices
should be ON or BLINKING.
8 Once the gateway is online, most Internet devices will have immediate Internet
access.
Note: If your PC does not have Internet access, refer to How Do I Configure
TCP/IP Protocol? for information on how to configure your PC for Internet
access. For Internet devices other than PCs, refer to the DHCP or IP Address
configuration section of the User Guide or Operations Manual for those devices.
4028315 Rev A
Gateways used in North America have multi-line capability on the RJ-11
telephone port labeled 1/2. Line 1 is on pins 3 and 4 of port 1/2, and
Line 2 is supported on pins 2 and 5. Gateways used in Europe support
only one line per port. Line 1 is on port 1 and line 2 is on port 2.
Telephones that require electrical connectors other than RJ-11 may
require an external adapter (sold separately).
How Do I Connect My Gateway for Internet and Telephone Service?
25