Table of Contents
Advertisement
4.
Insert a thin tool into the keyboard release hole in the optical drive bay, and then press on the
back of the keyboard until the keyboard disengages from the computer.
5.
Turn the computer right-side up, with the front toward you.
6.
Open the computer as far as it will open.
7.
Lift the rear edge of the keyboard until it rests at an angle.
8.
Swing the rear edge of the keyboard (1) up and forward until it rests upside down on the
palm rest.
9.
Release the zero insertion force (ZIF) connector (2) to which the keyboard cable is attached, and
then disconnect the keyboard cable from the system board.
10.
Release the ZIF connector (3) to which the pointing stick cable is attached, and then disconnect
the pointing stick cable from the system board.
NOTE:
Step 11 applies only to computer models equipped with a keyboard with backlight.
11.
Release the ZIF connector (4) to which the backlight cable is attached, and then disconnect the
backlight cable from the system board.
Component replacement procedures
65
Hide quick links:
Advertisement
Table of Contents
