Plumbing Problems; Accessories; Performance Data Sheet - Kenmore 106.8955 Series Use & Care Manual

PROBLEM
Water Not Entering Drain
Properly
To order accessories, call 1­800­4­MY­HOME
appropriate part number listed below or contact your
authorized Kenmore dealer.
Water Filter
Order Part Number 9934
Model P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571 Liters)
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal
to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42.
Substance Reduction NSF Reduction
Aesthetic Effects Requirements
Chlorine Taste/Odor 50% reduction 1.9727 mg/L 2.0 mg/L ± 10%
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters).
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
Use replacement filter P6RFWG2K, P6RFGEG2K,
P6RFKG2K, Part Number ICE2.
Style 1 – When the water filter status display changes from
"GOOD" to "ORDER," order a new filter. When the filter
indicator reads "REPLACE," it is recommended that you
replace the filter.
Style 2 – Press FILTER to check the status of your water filter.
If the filter indicator light is yellow and the words "ORDER
FILTER" appear on the display screen, order a new filter. If
the filter indicator light is red, it is recommended that you
replace the filter.
These contaminants are not necessarily in your water supply.
While testing was performed under standard laboratory
conditions, actual performance may vary.
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
® NSF is a registered trademark of NSF International.

Plumbing Problems

WARNING
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
RECOMMENDED SOLUTIONS
Is the drain hose aligned over the drain? Move the ice maker to align the drain. See "Connect
Water Supply."
NOTE: Service technicians cannot repair plumbing problems outside of the ice maker. Call a
licensed, qualified plumber.
and ask for the
®

PERFORMANCE DATA SHEET

Ice Maker Water Filtration System
System tested and certified by NSF
International against NSF/ANSI
Standard 42 for the reduction of
Chlorine Taste and Odor.
Average Influent Challenge
Influent Concentration

Accessories

Cleaner
Order Part Number 4396808
Stainless Steel Cleaner
Order Part Number D22 M40083 R
Maximum
Effluent
0.71 mg/L
Refer to the "Warranty" section for the Manufacturer's
name, address and telephone number.
Refer to the "Warranty" section for the Manufacturer's
limited warranty.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
Average Minimum %
Effluent Reduction
0.7788 mg/L 70.2
City or Well
30 - 120 psi (207 - 827 kPa)
33°- 100°F (0.6° - 37.8°C)
0.50 gpm (1.89 Lpm) @ 60 psi
Average %
Reduction
72.81
21